No temperature info
In a WDC harddrive (report below) CrystalDiskInfo does not show temperature. As i think this is because there is no C2 attribute but it can use BE as it .
---------------------------------------------------------------------------- (1) WDC WD3200AAJS-60Z0A0 -- S.M.A.R.T. -------------------------------------------------------------- ID Cur Wor Thr RawValues(6) Attribute Name 01 200 200 _51 000000000000 Read Error Rate 03 131 131 _21 000000001159 Spin-Up Time 04 100 100 __0 000000000022 Start/Stop Count 05 200 200 140 000000000000 Reallocated Sectors Count 07 100 253 _51 000000000000 Seek Error Rate 09 100 100 __0 000000000011 Power-On Hours 0A 100 253 _51 000000000000 Spin Retry Count 0B 100 253 __0 000000000000 Recalibration Retries 0C 100 100 __0 00000000001C Power Cycle Count B8 100 100 _97 000000000000 End-to-End Error BB 100 100 __0 000000000000 Reported Uncorrectable Errors BC 100 _99 __0 000000000001 Command Timeout BE _67 _63 _40 000000000021 Airflow Temperature C0 200 200 __0 000000000009 Power-off Retract Count C1 200 200 __0 000000000022 Load/Unload Cycle Count C4 200 200 __0 000000000000 Reallocation Event Count C5 200 200 __0 000000000000 Current Pending Sector Count C6 200 200 __0 000000000000 Uncorrectable Sector Count C7 200 200 __0 000000000000 UltraDMA CRC Error Count C8 200 200 __0 000000000000 Write Error Rate
I added Airflow Temperature (Attribute ID 0xBE) support in CrystalDiskInfo 3.9.4. Please test and report it.
Now works as expected, thanks a lot !!
hiyohiyo 
CrystalDiskInfo
In a WDC harddrive (report below) CrystalDiskInfo does not show temperature. As i think this is because there is no C2 attribute but it can use BE as it .